Licensed Electrician Needed for Wiring and Adding Circuits

Kenmore WA

Description

Licensed Electrician needed for wiring and adding circuits to an inspected subpanel for an in progress ADU. My electrician installed a subpanel (inspected) and wired it from the main panel (also inspected and approved). Need to hire a licensed and bonded electrician to finish the job - wiring the permitted ADU and adding circuits before the rough-in city inspection. Any electrical work that needs to be permitted with be required (adding circuits for example). List of tasks: 1. Kitchen circuits - 8x8 junction box - location to be in the cabinet wall, per location of cabinet -Range -20 amp circuit for hood fan/(microwave) -Small appliance (2 20 amp circuits) -Dishwasher (15 amp) -Garbage disposal 2. Heaters (20 amp each) and thermostat -Bedroom (220) -Kitchen (220) -Power to thermostat and then heaters -Bath - heater has embedded thermostat - 120V 3. 3-way wire and a hot wire from the existing switch located inside kitchen entry from hallway to switch location for outdoor lights and outside entry light -Wires need to go to appropriate locations and into junction boxes -Determine location of where the junction box inside closet (by outside door) goes. 4. (3) exterior motion lights (2) in front entry wall and (1) at door entry -Switch placement TBD at time of install 5. Install chandelier (have already determined wiring can be done 6. Install 2 overhead lights in hallway 7. Hardwire smoke and carbon monoxide detectors (this list may be changed) Requirements: 1. Licensed (will verify) 2. Bonded (will verify) Provide an estimate including $ and time and when you can start. Only responses with this info will be considered.