2002 Jeep TJ

Pottsville PA

Description

2002 Jeep TJ, 4.0, Manual, 102k miles. - Half doors - Intense blue pearl - Black interior - Black soft top - Hard top - Mastercraft Nomad suspension seats with 5 point harnesses - front bumper with rad guard and mini stinger - rear bumper - Rockers with steps - custom roll cage - harness bar - Warn steering box skid - Edge Performance cold air intake - Edge Performance throttle body - Edge Performance tuner - Banks Monster Cat-back exhaust - KC round lights - Light bar - Rock lights - Rough Country 4" long arm lift - Rough Country stainless steel brake lines for the soft lines. - All brake hard lines along the frame and vehicle were replaced with a stainless steel kit - Currie tie rod - Currie Antirock front sway bar - 8000lb Winch Front Axle - LP Dana 30, Detroit locker, 4.88 gearing, external axle seals, Artec lower control arm mounts, timken bearings (1 yr old), Spicer ball joints (1 yr old), upper truss, Ruff Stuff diff cover. Just serviced with new fluid. Rear Axle - Ford 8.8, 4.88 gearing, Detroit locker, disc brakes, Ruff Stuff diff cover, Artec truss/swap kit, East Coast Gearing Supply e-brake kit for the 8.8 swap (this will need to be adjusted to tighten it up). Just serviced with new fluid. - 35"x12.50"x15" Goodyear Wrangler MTRs with roughly 60% tread - Front fenders are custom high clearance design using DOM steel - rear body armor fenders - poison spyder hood insert. The windshield wiper washer needs to be installed yet I never cut the hole out for it. - Brown Dog Industries motor mounts - LED tail lights - LED turn signals - Replaced windshield frame and cowl. Both were bed lined in the process. - Pulled door panels from the half doors and bed lined. Reinstalled panels. - Used the Eastwood Company system to spray the inside of the frame for rust prevention - Tub was completely gone over and rust was cut out and welded new patches in and whole interior was repainted - new oil pan and gasket - new rear main seal while I changed oil pan - new radiator - new water pump - new thermostat - new hoses - new alternator and belts - new clutch fan - tune up was done before I did the other stuff maybe 2 years old - 5 Brand new 15x8 5x4 with 3.75 back spacing pro comp rock crawler steel wheels. 4 with bead lock kit never installed for an extra 600 dollars - Needs an inspection I haven’t been really driving it much lately so I let the inspection run out. Should pass with no issues. Runs and drives great. - The rear of the frame should be sleeved and welded around where it arches. I just never got around to do it. It’s an easy fix for a welder. As with any 20 year old off road vehicle there might be something else I'm not aware of but this is everything I know right now. Thank you. Price 12000 dollars. Sent from my iPhone Sent from my iPhone